GSSL Left & Right Volumes Aren't Perfect...
« on: May 06, 2010, 12:52:35 AM »
Hey everybody, I just finished my first GSSL (besides the front panel and cosmetics) and everything went very very smooth... Almost too smooth.  Plugged it in, tested the voltage points, dropped in the VCAs and passed a mix through it.  The compressor sounds amazing and is dead quiet.  I have only worked on SCA kits and a DIY Summer before this.  I was quite impressed.

Here's the issue: My right channel volume is about .5 decibel lower than the left.  Is there an easy solution to the problem?  I'm assuming that it's due to variance in the resistors or something of that nature.  I can always just adjust the track digitally once it's back in Pro Tools but I would much rather know what the issue is and how to solve it for my next build.

Any suggestions?

Thank you to everyone for your help and the endless amount of data here.  I am so inspired to take on the next challenge.

Happy DIYing!



Re: GSSL Left & Right Volumes Aren't Perfect...
« Reply #1 on: May 06, 2010, 04:12:19 AM »
..please use the official gssl-help-thread...

Jakob E.
..note to self: don't let Harman run your company..


Re: GSSL Left & Right Volumes Aren't Perfect...
« Reply #2 on: May 06, 2010, 08:41:24 AM »
Question reposted there.  Sorry about that...


Related Topics

  Subject / Started by Replies Last post
8 Replies
Last post September 17, 2006, 09:44:25 AM
by SSLtech
12 Replies
Last post September 28, 2006, 11:22:27 AM
by Adky
1 Replies
Last post January 12, 2013, 02:13:24 AM
by Govinda Doyle
10 Replies
Last post June 10, 2019, 09:37:15 PM
by Dualflip