ilfungo

neve 1073 + 660 combo
« on: November 25, 2018, 06:18:15 AM »
Hi I'm working on a 1073 pre/EQ + 660 Channelstrip.
I'm at the end of project I need just to rack inside the 660.
Only one problem regarding 1073:

When the eq go IN, the level increase of 3db...
It's normal?

The last question:
I want to have a true bypass of the single unit:
how can I configura the ralay to have:

a - 1073 only
b - 660 only
c -1073 + 660

THANKS!!!


ilfungo

Re: neve 1073 + 660 combo
« Reply #1 on: November 25, 2018, 07:15:14 AM »
When the eq go IN, the level increase of 3db...
It's normal?



Solved I've used 10k trim fader instead of 5k....


The last question:
I want to have a true bypass of the single unit:
how can I configure the ralays to have:

a - 1073 only
b - 660 only
c -1073 + 660

THANKS!!!
« Last Edit: November 25, 2018, 10:56:22 AM by ilfungo »

ilfungo

Re: neve 1073 + 660 combo
« Reply #2 on: November 28, 2018, 09:32:36 AM »
The unit is near to ready, and sound fantasctic!!!
Just 2 questions:
I don't know why when the input pot of 660 is full I've a great frequency responce,
but, when it ic from half way to down there is a roll off on low frequency... Screen shot attached
Suggestions?

Neve out
from the manual I've replaced the 5.1k resistor between  k and B- with a 5k pot ( for trim out)
but when I go down with trim there is a different level between eq in and eq out ( eq totally flat)
Suggestions?

Help please.... ;D ;D

ilfungo

Re: neve 1073 + 660 combo
« Reply #3 on: November 28, 2018, 09:34:08 AM »
and this at 1/4 of rotation

ilfungo

Re: neve 1073 + 660 combo
« Reply #4 on: November 28, 2018, 09:36:28 AM »
And this is the Frankenstein with temporary knobs...

ilfungo

Re: neve 1073 + 660 combo
« Reply #5 on: November 28, 2018, 09:46:20 AM »
The pot is 2k5 on the schematic....

ilfungo

Re: neve 1073 + 660 combo
« Reply #6 on: November 29, 2018, 03:58:48 PM »
 :(
nobody?


 

Related Topics

  Subject / Started by Replies Last post
3 Replies
2184 Views
Last post September 11, 2004, 04:45:16 PM
by peter purpose
6 Replies
5178 Views
Last post September 01, 2007, 04:06:32 PM
by audioforge
6 Replies
3591 Views
Last post November 20, 2007, 10:45:47 PM
by Gwaggin390
5 Replies
1577 Views
Last post May 12, 2009, 08:24:32 PM
by pucho812