Tannoy Crossover; Monitor Gold type LSU/HF/III.LZ/8

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

willbart

Member
Joined
Mar 21, 2018
Messages
8
Just a few basic q's re a crossover re-build fo type type LSU/HF/III.LZ/8;

I've opened them up and the 3.3uF capacitor & 0.5mH inductor on the HF output are in the opposite positions to those indicated on the schematic below - is this likely to be a mistake?

Or does it not matter for these components?
I've seen 2 versions of schematics for the 12/15" models that show both arrangements.

Also, I need an 8uF capacitor for the HF input (nearest is 8.2); would a 3.3uF & 4.7uF in parallel suffice?

MonitorGoldIIILZxo1.gif


Finally, can anyone recommend a good type of capacitor to use? - I don't want to let these speakers down but I don't want to break the bank either.
I've seen Jantzen Superior-Z recommended, but that will come to over £300...

Thanks
 
willbart said:
...I've opened them up and the 3.3uF capacitor & 0.5mH inductor on the HF output are in the opposite positions to those indicated on the schematic below - is this likely to be a mistake?..Or does it not matter for these components?
They are connected in series so it does not matter.
Also, I need an 8uF capacitor for the HF input (nearest is 8.2); would a 3.3uF & 4.7uF in parallel suffice?
Yes.
Finally, can anyone recommend a good type of capacitor to use? - I don't want to let these speakers down but I don't want to break the bank either.
Mundorf. Or any good MKP for 100V or higher.
https://www.audiophonics.fr/en/mundorf-capacitors-c-193.html
https://www.audiophonics.fr/en/condensateurs-mundorf-mundorf-mcap-250v-mkp-c-337.html
 
Back
Top