laus
Member
Hello everyone
I just buy a AM16 preamp and I have some problems to wire it.
I use a JLM 3 rails PSU and a JLM GoBetween.
I put the strap for 600 ohms IN (strap S to V and connect input + to T and input - to U), put the strap for 600 ohms OUT (strap C to B and connect output + to A and output - to D).
Also I use the High Power connection (strap H to K) so I connect the PSU 0V to P and the PSU +24V to M.
I think all is good until now.
here are my questions :
- It's written on the AM16 documentation that "the negative side of the PSU must be grounded at one point, and only one point"
Is it possible to only use the 0v and +24v or do I need to connect the -24V of the PSU to the 0v?
- Where do I have to connect the shields of my input and output?
- I've read some people connect the J pin to the ground star point, is that right?
Thanks in advance for any help you guys can give me?
Jul
I just buy a AM16 preamp and I have some problems to wire it.
I use a JLM 3 rails PSU and a JLM GoBetween.
I put the strap for 600 ohms IN (strap S to V and connect input + to T and input - to U), put the strap for 600 ohms OUT (strap C to B and connect output + to A and output - to D).
Also I use the High Power connection (strap H to K) so I connect the PSU 0V to P and the PSU +24V to M.
I think all is good until now.
here are my questions :
- It's written on the AM16 documentation that "the negative side of the PSU must be grounded at one point, and only one point"
Is it possible to only use the 0v and +24v or do I need to connect the -24V of the PSU to the 0v?
- Where do I have to connect the shields of my input and output?
- I've read some people connect the J pin to the ground star point, is that right?
Thanks in advance for any help you guys can give me?
Jul