Analog Tape Test Equipment

[maxwall]

moved thread to chamber

 

[Rogy]

Hi,

Have a look at Arta / Steps for computer-based distortion measurements:

http://www.artalabs.hr/

PS maybe better post in the Chamber as well for better visibility?

Good luck!

Rogy

 

[Walrus]

The Leader looks fine to me. If you want a load of 600 Ohms for the device under test just stick two 1.2K Ohm resistors (in parallel) across the input terminals!

 

[fazer]

What about REW with a computer for Distortion.  Lots of info in the DIY chamber test gear section or is The Studio section. 

 

[fazer]

For analog ,  I use an old HP 302 Wave analyzer.  You can look at the harmonic of interest rather than just a THD measurement.  But REW is very strong for this type of measurement

 

[maxwall]

thanks for the replies

I'll move this bit over to chamber