Hey all...
Just seen this: http://www.rapidelectronics.co.uk/rkmain.asp?PAGEID=80010&CTL_CAT_CODE=30325&STK_PROD_CODE=M29301&XPAGENO=1 which I was thinking I could use for some level indication on the yammy desk i'm reworkin, i'd have 2 sitting either side of the master fader (which is a p+g belt fader - hoping to use with mcs' relay att brd). They would fit perfectly in the already cut panels but the thing is some of the leds are connected in series (shown on datasheet)... would i just treat these as a single LED when using say one of those LM led driver IC's? Or are the other ways to go about it?
Thanks, and happy nye again!
D
Just seen this: http://www.rapidelectronics.co.uk/rkmain.asp?PAGEID=80010&CTL_CAT_CODE=30325&STK_PROD_CODE=M29301&XPAGENO=1 which I was thinking I could use for some level indication on the yammy desk i'm reworkin, i'd have 2 sitting either side of the master fader (which is a p+g belt fader - hoping to use with mcs' relay att brd). They would fit perfectly in the already cut panels but the thing is some of the leds are connected in series (shown on datasheet)... would i just treat these as a single LED when using say one of those LM led driver IC's? Or are the other ways to go about it?
Thanks, and happy nye again!
D