BM800 capsule mod

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
And the preamp, you can buy solo (you should try buying 2i2, you might regret later but again it depends on what you need)
I actually nearly forgot why it was named the ‘solo’ 🙄. I think it’ll be fine for now though.
Additionally, I won’t have to bother with a custom PCB for the CM25?
Check out this
Would you recommend the capsule used in the video/34mm LDCs in general? The comments seem to be mixed on it; is it better to go with the 25mm capsule linked earlier? I’ve also read that https://www.aliexpress.com/item/1005003678248617.html is decent too.
 
I actually nearly forgot why it was named the ‘solo’ 🙄. I think it’ll be fine for now though.
Additionally, I won’t have to bother with a custom PCB for the CM25?

Would you recommend the capsule used in the video/34mm LDCs in general? The comments seem to be mixed on it; is it better to go with the 25mm capsule linked earlier? I’ve also read that https://www.aliexpress.com/item/1005003678248617.html is decent too.
The JLI-3412 shown in the video is considerably better than the 2555.
https://groupdiy.com/threads/liking-this-34mm-transound-much-more-than-tsb-2555.80168/#post-1138859
 
Are there any known 34mm electret capsules on Aliexpress? I couldn't find any (judging by the operating voltage, and the fact that their descriptions don't mention being electret).
Electrets without built-in FETs don't have an 'operating voltage'; those Ali specs are nonsense.

I've never bought anything on Ali Express. I buy capsules from mfgrs (Oktava, Rode, etc.), JLI Electronics, FEL Communications (micbooster.com), or on eBay.

In case you weren't aware, you can tell electrets that have built-in FETs by the circuit board with solder pads on the back. Those w/o FETs have no circuit board on the back.
 

Latest posts

Back
Top