Hi
In regards to the (2)output 5k trim pots and 5k resistors on the Cavendish board, it's recommended in the installation instructions to remove the 7.5k's, there are no 7.5k's on my GSSL board, maybe they changed the values on a revision ? I recently just purchased the GSSL board from pcgrinder.
Where exactly are these resistors on the board. I read in a post it's the 15k accross pins 1,and 2 on the 5532(see attached PDF) do I jumper them or just remove them?
The post also mentioned to change the 5k trim, and 5k resistor to 10k.
Thanks
Tony Wisniewski
In regards to the (2)output 5k trim pots and 5k resistors on the Cavendish board, it's recommended in the installation instructions to remove the 7.5k's, there are no 7.5k's on my GSSL board, maybe they changed the values on a revision ? I recently just purchased the GSSL board from pcgrinder.
Where exactly are these resistors on the board. I read in a post it's the 15k accross pins 1,and 2 on the 5532(see attached PDF) do I jumper them or just remove them?
The post also mentioned to change the 5k trim, and 5k resistor to 10k.
Thanks
Tony Wisniewski