k brown
Well-known member
I gave this idea to Dave Royer but he didn't run with it; perhaps a DIYer with give it a go.
Picture a Crown PCC, but inside the 'cage' is a slim ribbon motor (like the AT4081) lying on it's side, imbeded in a thick-ish plate (like the Neumann GFM 132) so the surface of the plate is even with the edge of the ribbon.
You'd have a (half) figure 8 boundary mic with all the unique qualities of a ribbon.
Picture a Crown PCC, but inside the 'cage' is a slim ribbon motor (like the AT4081) lying on it's side, imbeded in a thick-ish plate (like the Neumann GFM 132) so the surface of the plate is even with the edge of the ribbon.
You'd have a (half) figure 8 boundary mic with all the unique qualities of a ribbon.
Last edited: