Eventide Flanger

[jensenmann]

Send me your email

 

[psych60s]

Send me your email

PM sent!

 

[JC120]

Bringing back the thread again, I couldn't find any calibration procedures for the Eventide Flanger in the manual, can someone let me know what test points and measurements I need to dial in? The flanging effect sounds weak. I could mess around with the trim pots but want to do it right. I've got a scope too. Thanks!

 

[Loftrunner]

Send me your email

Hi JM,

I'm looking for the schematic for the fl201 flanger card, I have the main unit schematic, and it looks like you might have it...or at least did in 2017! I've just registered here so I don't think I can send PMs or maybe I just can't figure out how...
If you do have it would you be kind enough to send to - replacing the 'at' and 'dot' with the respective symbols. Thanks

 

[jensenmann]

look here: https://mae.tcrcloud.de/index.php/s/rq8Kxt2A27Rc2c4?path=/Eventide

 

[Loftrunner]

look here: https://mae.tcrcloud.de/index.php/s/rq8Kxt2A27Rc2c4?path=/Eventide

Thanks very much JM! X

 

[Loftrunner]

Does anyone know the correct hex key size for the Instant Flanger knobs? I have one that's slightly too big and one slightly too small. Being a US product I'm assuming they're SAE sizes rather than metric, but the specific size would be great to know. Thanks

 

[Rob Flinn]

Does anyone know the correct hex key size for the Instant Flanger knobs? I have one that's slightly too big and one slightly too small. Being a US product I'm assuming they're SAE sizes rather than metric, but the specific size would be great to know. Thanks

Maybe UNC sizes