culteousness1
Well-known member
Hi all,
during my last build, I was needing a simple Line Receiver/Debalancing-Board.
Therefore, I had these boards made and want to sell my spares:
These accept either a INA134 (G=1) or a INA137 (G=1/2). Just add four bypass caps
and a screw terminal and you are done.
Board size is 32x26 mm, single sided. Note that I used all SMT components. But these
are anly SOIC8, 6032, 0805. So pretty easy to solder. Maybe a good practice or start
They are attached directly under the XLR and Pin 1 can be connected either to CHS or
to GND by a solder jumper.
I have ten of these available. Price is 3 Euros each. International Shipping costs 3 Euros.
If you have any question, please do not hesitate to shoot me a PM.
Cheers,
Carsten
during my last build, I was needing a simple Line Receiver/Debalancing-Board.
Therefore, I had these boards made and want to sell my spares:
These accept either a INA134 (G=1) or a INA137 (G=1/2). Just add four bypass caps
and a screw terminal and you are done.
Board size is 32x26 mm, single sided. Note that I used all SMT components. But these
are anly SOIC8, 6032, 0805. So pretty easy to solder. Maybe a good practice or start
They are attached directly under the XLR and Pin 1 can be connected either to CHS or
to GND by a solder jumper.
I have ten of these available. Price is 3 Euros each. International Shipping costs 3 Euros.
If you have any question, please do not hesitate to shoot me a PM.
Cheers,
Carsten