Hi,
today I finish my G-pultec and it works fine but the output signal is very strange on oscilloscope.
On output XLR i have this signal.The bigger signal is on XLR pin 3 ,and the smaller signal is on pin 2 XLR.
Is this OK signal or something is wrong.If I disconect the XLR wire from PCB and measure on transformer pins signal is the same.
today I finish my G-pultec and it works fine but the output signal is very strange on oscilloscope.
On output XLR i have this signal.The bigger signal is on XLR pin 3 ,and the smaller signal is on pin 2 XLR.
Is this OK signal or something is wrong.If I disconect the XLR wire from PCB and measure on transformer pins signal is the same.
