Bluegrass Bass Guy
Member
I've been putting together a parts list from Mouser for a pair of Green Preamps for a few months now (newbieness) and am all most done but have a few questions.
Can I put a VU meter on the Green? if so how? I would think it would be simple but I've read a few post here or somewhere that it could cause distortion unless I have some sort of buffer? ( I have no idea what I'm talking about I hope you do)
Are the LEDs something needed for the circuit? Can I just leave them off?
Which part from Mouser do I need for the 100k flat/multiturn trimmer?
I've been learning as I go along. I hope it all works in the end. It may end up being an expensive soldering lesson. :razz:
I enjoy this forum very much and read it everyday.
Thanks,
Harold
Can I put a VU meter on the Green? if so how? I would think it would be simple but I've read a few post here or somewhere that it could cause distortion unless I have some sort of buffer? ( I have no idea what I'm talking about I hope you do)
Are the LEDs something needed for the circuit? Can I just leave them off?
Which part from Mouser do I need for the 100k flat/multiturn trimmer?
I've been learning as I go along. I hope it all works in the end. It may end up being an expensive soldering lesson. :razz:
I enjoy this forum very much and read it everyday.
Thanks,
Harold