I got this old over engineered Microphone amplifier which I believe is some old test equipment
that went with the Neumann MM3(5) micorphone.
Got it working with a dynamic mic on the 10MΩ input but only measured the Condenser mic input
and one pin is ≈70v (HT?) but I believe should be 120v, lot of trimpots..
Anyway just checking to see if anyone have any info before I start to reverse engineer it
that went with the Neumann MM3(5) micorphone.
Got it working with a dynamic mic on the 10MΩ input but only measured the Condenser mic input
and one pin is ≈70v (HT?) but I believe should be 120v, lot of trimpots..
Anyway just checking to see if anyone have any info before I start to reverse engineer it
