pucho812
Well-known member
Anyone know of a place to get 500 series metal work for modules?
Looking to make some 500 series stuff and my hold up is metalwork…
Looking to make some 500 series stuff and my hold up is metalwork…
Metal work for 500 series
- Thread starter pucho812
- Start date
Help Support GroupDIY Audio Forum:
Are you thinking of the L bracket specifically? Frank at frontpanels.de can make them for you with whatever drills/cuts you want, and I believe CAPI also offers un-drilled L brackets for DIY (drill it yourself!). As for front panels, of course, you would get those done for 500 series just like a 19" unit, but using the format's dimensions.
pucho812
Well-known member
both actually. But that is a good bit of information. thank you
Dimensions are available from VPR Alliance. Hope that helps!
john12ax7
Well-known member
If you are going to NAMM there are usually a couple booths of metal fab to talk to.
And MD&M West will be in Anaheim a couple weeks after. Lots of shops there, some that will do 100 pcs. Others will assume you mean 100k when you say 100.
So a lot depends on quantities needed. For a few faceplates it is often easier and cheaper to use front panel express.
And MD&M West will be in Anaheim a couple weeks after. Lots of shops there, some that will do 100 pcs. Others will assume you mean 100k when you say 100.
So a lot depends on quantities needed. For a few faceplates it is often easier and cheaper to use front panel express.
