Nice looking mic body ......

[gary o]

http://www.dv247.com/microphones/fame-studio-c02-condenser-microphone-nickel--200969

Any info anyone

 

[gary o]

Ah ..... this is smaller than I thought , went to shop had a look not much use for DIY

 

[poctop]

This will host the D87 taper.
Best,
Dan, <

 

[EEMO1]

i bought one for my 87 build. what do you want to know?

 

[gary o]

I thought body was bigger, U 67 size ,but not.....

 

[pedroplanet]

what about this one?
http://www.ebay.com/itm/ws/eBayISAPI.dll?ViewItem&item=111182189555&item=111182189555&lgeo=1&vectorid=229466

very cheap chinese mics showing up on ebay.

 

[RuudNL]

I bought a couple of those cheap Chinese microphones a short while ago, just for the bodies.
About everything on them is crap!
The bodies are made of aluminium, the thread for the bottom ring wears very quickly.
The (SMD) electronics are noisy as hell and the capsule is a (small) cheap electret.
The microphones sound like you are speaking with a bucket over your head!...
I put some real capsules in them and replaced the electronics completely.
Now I can use them!

 

[EEMO1]

Ah ..... this is smaller than I thought , went to shop had a look not much use for DIY

the fame co2,


quite the opposite as far as diy goes. I built the d87 inside one of these and it works like it should. I built a low-cut and high end emphasis with the switches. no polarity or pad.



on a side note. I was suprised with the stock components. styroflex caps etc... could be decent on it's own already.