NTP 179-400 clicks

[andow]

Hi andow, do you remember which Lorlin used on your device, BCK100X, cause there is a few and it's very confusing since there is also two type of code, 33 and 43

https://groupdiy.com/threads/ntp-179-400-stereo-link.78965/post-1021259
I think I used BCK1001.

 

[noiro]

ok I'll make sure that I can at least get similar one, most distributor are backorder, so anyway that project is put on hold. I was thinking to get the BCK1006, it has a stop, then 1001 has no stop, so does your just keep on rotating, I know you can used the movable lug to get it to the number of dial you need.

 

[noiro]

I just find out there is also a whole series of BCKS, damn!

 

[andow]

These switches don't have an adjustable end stop! Yes, the one I used on this unit goes all around.

The BCKS is just the sealed version...

 

[tommia]

I'm not happy with my NTP's. I have a slightly different model, same number. On the front panel there is a switch for limiter on/off. If I engage the limiter I got clicks on the peaks esp on fastest releases. Normally this is done on the connector (pin 16 iirc).
What is your prefered position for your switches?
I have to do something wrong.


Ps : Powered from a 24 volt powersupply. Linked or unlinked, it stays the same.
The timeconstant switches are linked to both limiters so there is only one switch for t1 and one for t2.

 

[tommia]

I had the same problem with clicks, unit not working properly. Changed the powersupply, all good now. Don't use switched powersupplies on this one. As said before: PSU from Volker!