okgb
Well-known member
Here is the first one , a little messy but wait
And what did you learn on this one Greg ?
Well ..............when putting something together [ at least for me ] make
sure you have ALL the parts , mark holes to drill with parts in place , then make ALL harnneses & wiring then check parts postions WITH wires
There were a few Oops in this one , never as clean in the end when one
has had enough and i didn't even the get the 2nd set of outpur xfmrs in there , not that they need them at all
The faceplate was made by dtt , who comes around here every now & then
I'll add some notes to the G.R. pcb thread , regards Greg
And what did you learn on this one Greg ?
Well ..............when putting something together [ at least for me ] make
sure you have ALL the parts , mark holes to drill with parts in place , then make ALL harnneses & wiring then check parts postions WITH wires
There were a few Oops in this one , never as clean in the end when one
has had enough and i didn't even the get the 2nd set of outpur xfmrs in there , not that they need them at all
The faceplate was made by dtt , who comes around here every now & then
I'll add some notes to the G.R. pcb thread , regards Greg