So i've been working on the modules today.
Had a proper look at the EQs.
Its passive but sounds great!
Will be good for mastering and fine eq tuning.
I'm going to use an AM7/4 for the gain stages. Which need +/- 24VDC
Which brings me to the PS2/49 power supply unit.
Now i cleaned it up and tested as much as i could before powering it up.
Turned it on (whilst hiding under the desk :-[) and it gives off a fairly loud hum.
I have no schematic or pin out for it.
Theres four output pins connected.
I'm getting +48, -48, 0, and 0.
I was expecting +/- 24v so does this mean it uses a floating ground reference and i should link a couple of terminals?
some pics anyhow
the eq guts,
PSU
Had a proper look at the EQs.
Its passive but sounds great!
Will be good for mastering and fine eq tuning.
I'm going to use an AM7/4 for the gain stages. Which need +/- 24VDC
Which brings me to the PS2/49 power supply unit.
Now i cleaned it up and tested as much as i could before powering it up.
Turned it on (whilst hiding under the desk :-[) and it gives off a fairly loud hum.
I have no schematic or pin out for it.
Theres four output pins connected.
I'm getting +48, -48, 0, and 0.
I was expecting +/- 24v so does this mean it uses a floating ground reference and i should link a couple of terminals?
some pics anyhow
the eq guts,
PSU