Reply to thread

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Terminal 13 on D is where you connect the shield of the output cable. The shield from the input cable should be connected to Pin b2. The circles around the in- and outputs are the shields. So connect them accordingly.

Terminal 5 and 7 on connector C is where the remote control unit is connected to. Do you have the schematic for that one? As far as I know the pins correspond. So connect Terminal 5 from the V713 to Terminal 5 from F713 and the same for Terminal 7.

Terminal 9 and 10 are the in- and ouput of external filters for the sidechain. If you don't use them you should bridge them. I would put them on jack plugs and use them. They can be fun to play with.

Terminal 12 is for the external instrument/meter.


Back
Top