SOLVED - AML EZ 1073 clicks and pops

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

kifa

New member
Joined
Oct 9, 2017
Messages
1
I finish build 1073 and I have a problem:
when i switch gain on mic on 2 last positions i have a very loud clicking in monitors
and when i use line, I have clicking too, in all positions, but in position 9 and 10 dont,
(it happens when i change positions on gain knobs)
somebody can help me what is the problem?
 
Greetings,

What was the solution you found? I had a similar problem with a factory Neve 1073 and it ended up being one of the small caps on the 283 board, if I recall correctly.

Regards, Jim
 
Back
Top