submergent's Drip Pultec V2 build

[submergent]

well, not so much a build thread as i blasted through the build and only took pics of the end steps...
but sure enough... turned it on and worked right outta the gates. actually used it on a session an hour after finishing it. here's some picks of the final assembly...

eq boards in ... knobs ready...

 

[submergent]

knobs on.
those things were pricey.

 

[submergent]

readying the case from Collective Cases...
very nice construction... just had to drill out the power switch  and file out the pilot light holes a bit.
also - do yourself a favor and mark your mounting holes (on the bottom panel) before you populate the main pcb. since i didn't do that i had to put the standoffs on and paint the bottoms of them with white paint and then put it into position to mark where the holes needed to go.

 

[submergent]

poppin' holes...

 

[submergent]

mounting the main pcb.
i had to add some height there to get the bottoms of the tanny assemblies off the bottom of the case.

 

[Bowie]

Looks great, thanks for the pointers!

 

[Trench Recordings]

What do you think ? how does it sound and what caps did you go with ?

-Dave

 

[submergent]

sorry for the late reply!

what caps did i use?
no way i'm gonna remember that.... haha! good ones. lets leave it at that.

sound?

i have a pair of these now, and they are used on every mix, guits, kicks, snares, vocal. whatever.
super hi-fi sounding. cannot get a bad "too-EQ'd" sound out of them.

LOVE 'EM!

-pete