signalflow
Well-known member
1. I'm trying to design my front panel with FPD. The trouble I'm having is that there are no ruler guides Right now I'm roughing it out then printing to see if it's correct. How are people getting these measurements correct without a ruler guide?!
2. I want to add inserts to the 9k pre's I'm building but I want to use a multi-pin connector(db25 or something). a) Can I just put it between the un-bal. output and the balancer board or is there much more to it than that? b) Will the audio still pass through even when nothing is connected?
Any help is greatly appreciated......dumbed down explanations welcome :wink:
Casey
2. I want to add inserts to the 9k pre's I'm building but I want to use a multi-pin connector(db25 or something). a) Can I just put it between the un-bal. output and the balancer board or is there much more to it than that? b) Will the audio still pass through even when nothing is connected?
Any help is greatly appreciated......dumbed down explanations welcome :wink:
Casey