WTB: RCA 77 Grille

[Colorblind]

It’s probably a long shot, but I thought I’d put it out there. Ideally a 77B or 77C without the pattern selector, but I’d consider a D/DX at this point.

 

[mjrippe]

Currently "Sold Out" at Big D Broadcast Exchange, but you might send an email.
https://www.bigdmc.com/rca-mic-parts

 

[Colorblind]

Currently "Sold Out" at Big D Broadcast Exchange, but you might send an email.
https://www.bigdmc.com/rca-mic-parts

Thanks. I did stumble upon that site. $350USD is a little more than I’m hoping to spend, but a good last resort if I can’t find a used one, assuming more will be available.

 

[Colorblind]

I wonder how close in size this grille would be:

https://mxlmics.com/products/cr77
Diameter looks about the same (2.5” approx), and I could also use the yoke.

 

[a soBer Newt]

Check with AEA they should have a few.

 

[Colorblind]

Thanks for the suggestion. I did ask but they don't have any RCA 77 parts. I ended up finding an old 77DX grille. That'll do for now. Still need to find a yoke/fork, which is shorter than that of a D/DX.

 

[Whoops]

Contact ENAK, those are the most experienced people in the World in RCA ribbon mics repairs and parts.

They have all the parts available for RCA mics:

https://www.enakmic.com/

 

[Colorblind]

Contact ENAK, those are the most experienced people in the World in RCA ribbon mics repairs and parts.

They have all the parts available for RCA mics:

https://www.enakmic.com/

Thanks, I’ve been going back and forth with Clarence a little bit. Hoping he can get me sorted!