CurtZHP
Well-known member
http://www.zerrohouseproductions.com/g1176pcb.jpg
You'll see from the picture that portions of the board got hazed out during the etching process. Fortunately, most of this happened on the large ground plane areas. You can also see how I attempted to "repair" it in a few spots. How critical is this to the circuit? Is it OK, or should I just bite the bullet and etch another board?
You'll see from the picture that portions of the board got hazed out during the etching process. Fortunately, most of this happened on the large ground plane areas. You can also see how I attempted to "repair" it in a few spots. How critical is this to the circuit? Is it OK, or should I just bite the bullet and etch another board?