boji
Well-known member
So after reading gdiy kindly wisdoms on the benefits of PFL, I feel I should add it to my input card.
I have no circuit references, so I'd like to ask a few questions about it if that's ok.
I get that AFL is just a cv telling all other channels to mute. That part I have wired right. WIth respect to API type circuits, should the PFL signal be pulled from A1's TX out AFTER the insert point, sent to a 47k resistor, and then passed on to the backplane, just like an aux or group bus?
What should it do when it's not activated-- may it just float open off a relay, not connected to anything?
Also this may seem obvious, but to be clear, when activating PFL, I want the stereo program bus muted to the monitors, but leave that same signal free and clear going to DAW, and possibly with the same relay, switch monitor input over to the solo bus, kind of like an insert?
Thanks for your thoughts,
-Boji
I have no circuit references, so I'd like to ask a few questions about it if that's ok.
I get that AFL is just a cv telling all other channels to mute. That part I have wired right. WIth respect to API type circuits, should the PFL signal be pulled from A1's TX out AFTER the insert point, sent to a 47k resistor, and then passed on to the backplane, just like an aux or group bus?
What should it do when it's not activated-- may it just float open off a relay, not connected to anything?
Also this may seem obvious, but to be clear, when activating PFL, I want the stereo program bus muted to the monitors, but leave that same signal free and clear going to DAW, and possibly with the same relay, switch monitor input over to the solo bus, kind of like an insert?
Thanks for your thoughts,
-Boji