Thanks for your answer but I don't need pinouts.31105 Pinout from Geof Tanner:
A = mic input +
B = mic input -
D = line input +
E = line input -
H = Pre-eq send (link to J)
J = Pre-eq return (link to H)
L= Post-eq send (link to M or fader)
M = Post-eq return (link to L or fader)
N = Gain boost (don't use)
R = +24v audio supply
S = 0v audio supply
T = unbalanced output
U = balanced output +
V = balanced output -
W = master mic/line control dc
X = +24v Leds/relays
Y = 0v Leds/relays
Z - chassis... make darn sure it goes to ground.
If I haven't listed a pin, nothing goes to it.
Make sure that the power supply can push out at least one amp... the bigger the better and is linear operation, fully regulated, with ripple and noise well below 1mV if possible.
https://gearspace.com/board/high-end/98702-wiring-up-neve-31105-module.html
I'm not working on an original unit. I'm building a custom unit for a customer mostly with original components (knobs, transformers, inductors) with a single mid band with multiple values.No markings on the capacitors themselves?
Enter your email address to join: