[Soeren_DK]

I thought we could make a big thread. Its easyer to find..

I got this problem with voltage in my g9.

I have replaced the to caps cause I had some hum with only 100u. Thought it could be that so I put some 220U caps and 4 0.6W 400ohm paralled over the + on the caps. But the hum was still there and louder.

This are the voltage Iam been reading....  :shock:  :shock:




Best regards
Soeren

[EZ81]

Are the Zeners and the 1N4004 installed in the right direction?

[Viitalahde]

You have the resistors paralleled like what? The hum shouldn't get any louder.

Is your filtering done like this:

--->rect. AC--->220uF to gnd--->resistors---->220uF to gnd----->DC out

 :?:

[Viitalahde]

Hey, I think you don't have enough voltage before the regulator in the first place. 282v before and 280v after that 470ohm resistor?

[Soeren_DK]

You have the resistors paralleled like what? The hum shouldn't get any louder.

Is your filtering done like this:

--->rect. AC--->220uF to gnd--->resistors---->220uF to gnd----->DC out

 :?:

No... Bummer. The resistor was placed direct over the to + connetores on the caps. I removed it.. Hmmm... Now I am reading 300V on C14 and 241V on C15... And there is still humm...  :shock:

[Soeren_DK]

Could it be some bad diodes???

LA2A building thread for newbies

Started by Arrigotti « 1 2 » Dynamic Processors

calrec PQ1549 help thread

Started by JayDee « 1 2 ... 21 22 » Filters/Equalizers

Help - can't access thread !

Started by clintrubber The Lab

Help, where did my Varicom thread go???

Started by jensenmann The Lab