Sharky

Resistor I.D.
« on: November 08, 2005, 09:57:20 AM »
Can some knowledgble kind soul give me a Maplin equivilent part number for this componant please. I have quoted exactly as it was written.

1/8W 6,8k 0805 SMD Resistor (Code 421900682).

I don't want to go & ask as they usually give me the wrong part despite what you tell them.


Resistor I.D.
« Reply #1 on: November 08, 2005, 10:00:19 AM »
Sharkey,
Are you sure you want a surface mount part?
http://www.lazpro.com
I reserve the right to not sell to idiots

Resistor I.D.
« Reply #2 on: November 08, 2005, 10:23:28 AM »
Sharky
What do you need it for?
I assume it is in a mic preamp - which one?

Avoid Maplin - surely you have a local TV repair shop you can buy some resistors from (where are you??)

TedF

Resistor I.D.
« Reply #3 on: November 08, 2005, 10:23:46 AM »
Hey Sharky, According to my current catalogue, they don't do surface mount resistors any more.
The nearest thing is M6K8 which is the standard metal film resistor.

Sharky

Diagram
« Reply #4 on: November 08, 2005, 10:33:04 AM »
Hi again,

I posted a new topic by accident. Anyway here is the circuit diagram from the manuf. See link below. What would suffice in place of this part. I need it to be as good as it is a microphone & it's go to be clear & audible.


http://circuitlab.no-ip.com/uploads/view.php?place=61&start=0

Thanks.

Resistor I.D.
« Reply #5 on: November 08, 2005, 10:36:01 AM »
Get the M6K8 that Ted suggested.
http://www.lazpro.com
I reserve the right to not sell to idiots

TedF

Resistor I.D.
« Reply #6 on: November 08, 2005, 10:43:24 AM »
Yes, the conventional component would be fine.... there should be plenty of room inside the jack plug.

Sharky

Resistor I.D.
« Reply #7 on: November 08, 2005, 10:54:55 AM »
Thanks to all who replied. What a service on here. Faster than a Ferrari, lol.

Resistor I.D.
« Reply #8 on: November 08, 2005, 11:36:34 AM »
More like an old MGB running on three cylinders..!!
http://www.lazpro.com
I reserve the right to not sell to idiots

Sharky

Resistor I.D.
« Reply #9 on: November 08, 2005, 12:03:10 PM »
Just soldered the suggested resistor in place & it sounds great. Great to get use of this headset at last. Thanks again.


 

Related Topics

  Subject / Started by Replies Last post
8 Replies
2512 Views
Last post June 29, 2004, 01:13:41 PM
by b3groover
2 Replies
2315 Views
Last post July 28, 2004, 07:27:24 AM
by SSLtech
1 Replies
1653 Views
Last post December 21, 2004, 01:59:03 AM
by Ian MacGregor
9 Replies
2522 Views
Last post February 21, 2005, 10:01:44 AM
by jensenmann