finished nite EQ3d (pics inside)

and the panel has What to do with sound?
:?:
.
.
.
well, obviously nothing , to the astute,
.
.
.
.but the proof is left for an exercise to the Neanagthrrhkals!

And god save the Mountain Gorilla.

Did some measuring tonight with the pots and i must say, all pots measured about 55k in center position which i think is acceptable.
When i go to 50k the pot itself is only turned a real small amount from the centre so i left it that way because i thought it wouldn't matter that much anyway.
Or am i mistaking here?

[quote author="dagoose"]Did some measuring tonight with the pots and i must say, all pots measured about 55k in center position which i think is acceptable.
When i go to 50k the pot itself is only turned a real small amount from the centre so i left it that way because i thought it wouldn't matter that much anyway.
Or am i mistaking here?[/quote]

That's not bad at all.
I took a real good look at the schematic just to make sure... & to me it look like there'd be no problem with dropping that series 5.6k down (Possibly even removing it)
But if your actually getting 55k @ Center... put a 580, 600 or 620 ohm in there instead & you'll be super close on! :wink:

You used the OMEG pots from Colin right???
If they're really that close I may get some too. :green:

Good luck with the EQ & I'm glad you like it.

OK... Who's next? (with they're finished Nite EQ3D) :razz: