Calrec PQ1549 rev.4 from the Gyraf
« on: July 12, 2012, 07:02:04 AM »
Hello Guys
For some time I have a problem with the 1549 EQ.
When you start it turned out that only work Low-Mid and Hi-Mid Sections.
The high does not work ... potentiometers rotate as nothing changes.
and the lower section shall be instituted and began working as a generator.
Maybe there is a problem with feedback somewhere, but I can not find it.
for the record. I complied with all the polarities of the scheme and I measured voltages. examined several times for installation errors. IC sockets are not covered directly soldered to the board.

Sorry for Bad English...
Thank you for Help...


gyraf

Re: Calrec PQ1549 rev.4 from the Gyraf
« Reply #1 on: July 12, 2012, 10:29:52 AM »
Please use the dedicated help thread - that way any solution can be re-used later by someone with related problems:

calrec PQ1549 help thread: http://www.groupdiy.com/index.php?topic=5957.0

Similar problems has been seen before, I think - often in higher frequency bands

Jakob E.
..note to self: don't let Harman run your company..


 

Related Topics

  Subject / Started by Replies Last post
422 Replies
103370 Views
Last post August 25, 2018, 10:11:21 AM
by musika
4 Replies
1560 Views
Last post September 20, 2013, 06:47:12 PM
by Harpo
7 Replies
2739 Views
Last post September 18, 2008, 12:49:57 PM
by TomWaterman
6 Replies
2449 Views
Last post November 12, 2009, 02:42:14 AM
by Audioman