Hi
A few questions :
I have a drip opto 4 pcb and a case without a cutout for I/O and O/P transformers. Do I need to mount the A24 on the outside too or is mounting the UTC HA-100X on the outside of the case sufficient? (I have seen a coulple of people mounting the A24 on the inside. ) How far from the Torodial do i need to be with the HA-100X? I have pre drilled holes for the XLR and there is not much room beside mounting the HA-100X in the middle of the backside. Is that ok?
I need to cut holes for for both the connections and the 4 4 40 screw for each transformer. Anyone have a template for cutting the holes for these two? I found them using the search function but the links where dead.
Last question.. bear with me guys... I have bought used UTC HA-100X and UTC A24. Is there a way of testing them with a multimeter to see if they are working?
Thanks
A few questions :
I have a drip opto 4 pcb and a case without a cutout for I/O and O/P transformers. Do I need to mount the A24 on the outside too or is mounting the UTC HA-100X on the outside of the case sufficient? (I have seen a coulple of people mounting the A24 on the inside. ) How far from the Torodial do i need to be with the HA-100X? I have pre drilled holes for the XLR and there is not much room beside mounting the HA-100X in the middle of the backside. Is that ok?
I need to cut holes for for both the connections and the 4 4 40 screw for each transformer. Anyone have a template for cutting the holes for these two? I found them using the search function but the links where dead.
Last question.. bear with me guys... I have bought used UTC HA-100X and UTC A24. Is there a way of testing them with a multimeter to see if they are working?
Thanks