G
Guest
Guest
looking in side my avalons and other good gear ,
im seeing that most gain and control pots are just left as traces on
the circuit boards , vs point to point wiring where as most of the
conections going to potentiometers are sheilded.
are there any rights or wrongs of laying out a circuit board
with all the pot conections embeded with-in the design
or is it better form to "lift" the pot conections off board with shielded
wire at the conection points then reconecting at the destination point.
thanks if any one can comment , im rather torn with this in my designs
of pcbs.
driller45
sorry accidentally posted this to the lab instead of the drawing board. :sad:
im seeing that most gain and control pots are just left as traces on
the circuit boards , vs point to point wiring where as most of the
conections going to potentiometers are sheilded.
are there any rights or wrongs of laying out a circuit board
with all the pot conections embeded with-in the design
or is it better form to "lift" the pot conections off board with shielded
wire at the conection points then reconecting at the destination point.
thanks if any one can comment , im rather torn with this in my designs
of pcbs.
driller45
sorry accidentally posted this to the lab instead of the drawing board. :sad: