boji
Well-known member
I decided to post this here and not on Jeff's ACA/Bo build thread since I'm still in the fact finding stage.
My question is to Jeff or anyone who has experience configuring ACA's.
Jedi Jeff chose in his 32ch desk one inverting ACA per 8 channels, 4 ACA's to a card.
(Edit: if it wasn't clear, these ACA's are doubled for L & R, I'm just asking about one half the outputs.)
They sum to an ACA/Bo that inverts again and brings them all down to a 2 mix with fader and mults.
Since I'm going with 24 channels, should I use 3 of the 4 ACA's on the PCB (8:1) or drop inputs to 6:1 and use all 4 or...perhaps go with 12:1 and invert with only two ACA's? :
I'm using 47k bus resistors throughout.
What setup in your estimation would perform best?
Also, do you think using an ACA/Bo for Aux buses is overkill?
It seems an appropriate fit when selecting Cue's and inserts prefade.
Thanks in advance for your responses!
-Boji
My question is to Jeff or anyone who has experience configuring ACA's.
Jedi Jeff chose in his 32ch desk one inverting ACA per 8 channels, 4 ACA's to a card.
(Edit: if it wasn't clear, these ACA's are doubled for L & R, I'm just asking about one half the outputs.)
They sum to an ACA/Bo that inverts again and brings them all down to a 2 mix with fader and mults.
Since I'm going with 24 channels, should I use 3 of the 4 ACA's on the PCB (8:1) or drop inputs to 6:1 and use all 4 or...perhaps go with 12:1 and invert with only two ACA's? :
I'm using 47k bus resistors throughout.
What setup in your estimation would perform best?
Also, do you think using an ACA/Bo for Aux buses is overkill?
It seems an appropriate fit when selecting Cue's and inserts prefade.
Thanks in advance for your responses!
-Boji