Hi,
I had a problem with bad solder in pin 1 of the M2 connector.
While reconnecting the module to the console I've connected M2 in a wrong way and as I was turning the PSU on C11 explode like a rocket...
Since I don't have in hand a 1uF/35v tantalum cap I've replaced C11 with 1uF/50V electrolytic.
There's a special reason for using tantalum caps on C11 and C12 or it's OK to replacing them with good quality electrolytics?
*Full size image
http://i66.tinypic.com/k1qwl4.jpg
I had a problem with bad solder in pin 1 of the M2 connector.
While reconnecting the module to the console I've connected M2 in a wrong way and as I was turning the PSU on C11 explode like a rocket...
Since I don't have in hand a 1uF/35v tantalum cap I've replaced C11 with 1uF/50V electrolytic.
There's a special reason for using tantalum caps on C11 and C12 or it's OK to replacing them with good quality electrolytics?
*Full size image
http://i66.tinypic.com/k1qwl4.jpg