AML Preamplifier General Question

[jorrharris]

Hello, I am new to DIY electronics and I have a question about powering these units for calibration. The steps say to power up the module, test specific points, and then adjust the bias knob until you get a certain current. My question is, how are you guys powering these things up? Are you putting it in a 500 series chassis? I am assuming that makes it really difficult to access the test points and turn the bias knob. Do you open up the 500 series chassis for easier access to the inside of the module? Or are people powering these things some other way? Sorry for the noob question.

 

[Horizoneer]

You can get extender ribbon cables to do that stuff. AML do them, as do Soundskulptor and others.