I'm not sure where to post this question, so here goes.
I have a vintage API desk I have been rebuilding/restoring for almost the last year. I have decided to re-switch and re-pot nearly the entire desk. I have done/am doing, a few mods to the input channels and also on the monitor cards.
Basically, I'll need 400-10K log pots and 70-10K center detent pans. I've also decided to replace the 25K reverse log mic gain pots while I'm at it.
I figure it'll be good for another 35-40 years and I'll be taking the big dirt nap by then. :wink:
Anyhow, I have priced out the Clarostat 388 series from State and the Bourns 53 series from Mouser/Digi. I will get 500 of the 10K logs...(the last 100 is essentially free from State)
To compare:
From State, 500-10Klog, 70-10K dbl gang center detent pan, and 34-25K rev log is $5976 plus shipping. (With friction washers BTW)
From Digi, 500-10Klog, 250-10K dbl gang center detent pan, and 250-25K rev log is $5347 plus shipping. (Minimum of 250 on the customs)
That’s a huge frickin’ cost difference when you look at the whole thing.
Is Clarostat really that much better of a pot?
I know my desk had mostly Clarostat originally with a couple of AB’s here and there.
My slut side says make it right and use the Clarostats but my damn check book says group buy on the Bourns and save some cash. It’s really a lot of $$ difference. If I sold the pans and mic gains that I don’t need, at cost, I would save $2800 over the Clarostats. Not too mention, the extra 100 10K logs I really don’t need.
Damn. What ta do, what ta do????? :?
I have a vintage API desk I have been rebuilding/restoring for almost the last year. I have decided to re-switch and re-pot nearly the entire desk. I have done/am doing, a few mods to the input channels and also on the monitor cards.
Basically, I'll need 400-10K log pots and 70-10K center detent pans. I've also decided to replace the 25K reverse log mic gain pots while I'm at it.
I figure it'll be good for another 35-40 years and I'll be taking the big dirt nap by then. :wink:
Anyhow, I have priced out the Clarostat 388 series from State and the Bourns 53 series from Mouser/Digi. I will get 500 of the 10K logs...(the last 100 is essentially free from State)
To compare:
From State, 500-10Klog, 70-10K dbl gang center detent pan, and 34-25K rev log is $5976 plus shipping. (With friction washers BTW)
From Digi, 500-10Klog, 250-10K dbl gang center detent pan, and 250-25K rev log is $5347 plus shipping. (Minimum of 250 on the customs)
That’s a huge frickin’ cost difference when you look at the whole thing.
Is Clarostat really that much better of a pot?
I know my desk had mostly Clarostat originally with a couple of AB’s here and there.
My slut side says make it right and use the Clarostats but my damn check book says group buy on the Bourns and save some cash. It’s really a lot of $$ difference. If I sold the pans and mic gains that I don’t need, at cost, I would save $2800 over the Clarostats. Not too mention, the extra 100 10K logs I really don’t need.
Damn. What ta do, what ta do????? :?