Lowfreq
Well-known member
Hey all,
A long time ago I had an effects loop added to my Sovtek Mig50, so I could use my Marshall JMP-1 preamp with the Sovtek power section.
But also, long before I knew anything bout DIY, another tech took the loop out and put it back to it's origional format.
I've been itching to use the Marshall again, so I've been looking at this schematic http://blueguitar.org/new/schem/sovtek/mig-50.pdf , and trying to figure out where i would put the loop. I remember seeing one of the caps lifted off the board going to the 1/4" socket.
I'm more interested in the return of the effects loop so I can acess the power tubes, but I'd set up both if I can.
Should I be looking around the 47pf cap? or the .022uf caps?
Any guidance for this bonehead would be great. :wink: :thumb:
A long time ago I had an effects loop added to my Sovtek Mig50, so I could use my Marshall JMP-1 preamp with the Sovtek power section.
But also, long before I knew anything bout DIY, another tech took the loop out and put it back to it's origional format.
I've been itching to use the Marshall again, so I've been looking at this schematic http://blueguitar.org/new/schem/sovtek/mig-50.pdf , and trying to figure out where i would put the loop. I remember seeing one of the caps lifted off the board going to the 1/4" socket.
I'm more interested in the return of the effects loop so I can acess the power tubes, but I'd set up both if I can.
Should I be looking around the 47pf cap? or the .022uf caps?
Any guidance for this bonehead would be great. :wink: :thumb: