Deepdark
Well-known member
Hi guys
Quick one for you. I'm drawing a board for a LA2A within Expresspcb. It's my first ever experience of pcb designing. I'm using a 2 layer board.
First thing first, I know all footprints, all writting and components should be on the top layer. But all the traces should be on the top or the bottom layer?
Secondly, I run the HT and heaters on the other layer. Is it ok to do this? Once completed, should I ground fill both side?
Third, If I use a 0.020 width traces for signal and 0.030 for HT and heaters, is it ok?
Quick one for you. I'm drawing a board for a LA2A within Expresspcb. It's my first ever experience of pcb designing. I'm using a 2 layer board.
First thing first, I know all footprints, all writting and components should be on the top layer. But all the traces should be on the top or the bottom layer?
Secondly, I run the HT and heaters on the other layer. Is it ok to do this? Once completed, should I ground fill both side?
Third, If I use a 0.020 width traces for signal and 0.030 for HT and heaters, is it ok?