aryl
Active member
hey, i can't seem to find the link to the parts list for the green power supply. i found it once. if i could find the schematic, that would help.
i ordered an extra PS pcb from peter, as i'm going to use it to push 24v for another project(i'm sure i'll post a couple times about it). from what i gather all i'll need to chage is a resistor rating. i can figure that out. what i'm wondering about is the 48v. the green pre design uses 15v and a voltage tripler to garnish the 48v. with 24v, i'll need a voltage doubler. is the curcuit much different?
david
i ordered an extra PS pcb from peter, as i'm going to use it to push 24v for another project(i'm sure i'll post a couple times about it). from what i gather all i'll need to chage is a resistor rating. i can figure that out. what i'm wondering about is the 48v. the green pre design uses 15v and a voltage tripler to garnish the 48v. with 24v, i'll need a voltage doubler. is the curcuit much different?
david