Dreams
Well-known member
- Joined
- Jun 26, 2010
- Messages
- 338
This is the monitor path of a Langevin AM-407 output module. The top right pair (R40, 41) comes from the output transformer. The top left pair (R36, 38) comes from the reverb return, but normally just has a 130r resistor switched in shunted across. The bottom right pair (R42, 43) is monitor out hi and lo.
The board as is has no monitor level control, just that fixed pad, signal taken from the same point as the mix outs. I need a monitor control.
I have a lot of questions, but for simplicity's sake, what's going on here? Is that network of R39, 40, and 41 a U-pad? Does R31 and 35 make it a T-pad?
I'd like to make this adjustable, but i can't get my thoughts straight, any help is appreciated
The board as is has no monitor level control, just that fixed pad, signal taken from the same point as the mix outs. I need a monitor control.
I have a lot of questions, but for simplicity's sake, what's going on here? Is that network of R39, 40, and 41 a U-pad? Does R31 and 35 make it a T-pad?
I'd like to make this adjustable, but i can't get my thoughts straight, any help is appreciated