lm13700 and polystirene cap questions

[JAY X]

Hi!

Just two questions:

1). Polystirene xicon capacitor. (atached picture). These have no polarity, right? i have to connect one leg to gnd.

2). LM13700. I know that if i only use one section of it, I have to give the second half proper termination. usually tying pin 16 to -V. But if left unconnected, floating, nothing BAD should happen except more power consumption... correct?.

Jay x

 

[JAY X]

About the LM13700, i finally used both sides of it.

 

[zamproject]

Hey

Have a 13700 design on the bench, I was told that inputs to ground is enough, all others can be floating.

Poly cap are non polarized, but they are generally in axial form, with inner and outer alu foil/electrode.
It's preferable to have the outer foil leg connected to the lower impedance node, so in your case the gnd