gar381
Well-known member
Hi all
A buddy of mine wants me to design a plug in module for his
old 70s tangent bar board that he can just drop in his frame
to use for tracking in his project studio.
Here is a rough schmo (It still need a few revisions yet
like a dropping resistor for led as an example but you get the idea.):
BIG PICTURE
Working on cutting down the size of this .gif with out losing to much detail.
This guy is a lot like the amek 2500. I will be using BC560 transistors instead
of the ZTX214 or BC415 like the orginal Angela.
Here is the rough PCB layout for my buddys tangent:
I am thinking of designing a basic general purpose A10 mic pre card
without the tangent spec. details if there is interest.
GARY
A buddy of mine wants me to design a plug in module for his
old 70s tangent bar board that he can just drop in his frame
to use for tracking in his project studio.
Here is a rough schmo (It still need a few revisions yet
like a dropping resistor for led as an example but you get the idea.):
BIG PICTURE
Working on cutting down the size of this .gif with out losing to much detail.
This guy is a lot like the amek 2500. I will be using BC560 transistors instead
of the ZTX214 or BC415 like the orginal Angela.
Here is the rough PCB layout for my buddys tangent:
I am thinking of designing a basic general purpose A10 mic pre card
without the tangent spec. details if there is interest.
GARY