Newb setting up a PSU for api 312s

[buildafriend]

I was wondering if you could help me wire up the PSUniversal to my my EIC connector and to my triad magnetics VPT36-690 toroid

These access 312's are my first build without elaborate wiring instructions. I need to wire for 120 with an on switch (no LED's).

This might help you:

 

[Harpo]

I need to wire for 120 with an on switch (no LED's).

Transformers secondary connection in series: Tie red to orange and take this center tap connection to the left side hole 'gnd' of your AC connection on pcb. Yellow and black to the adjacent holes 'sec1' and 'sec2', order doesn't matter for AC.
Transformers primary connection for 115VAC mains in parallel: Tie blue to violet, further going to IEC neutral. Tie brown to gray, further going to mains switch throw position. Mains switch pole position to fuse holder. Other lug of fuse holder to IEC hot. IEC safety ground to case.

 

[buildafriend]

is a 1.5 amp switch big enough to be switching mains on and off?