Bananahead
Member
So, I traded an AML-modded Tac Scorpion and a box of spares for some other stuff. Hooking it up I only hear sound coming from the L output. Bus 1-8 is working fine but nothing from R. Not from the phones output(s) and not from the XLR in the back. 2-4-6-8 bus out meters are showing signal going to R but the R master output looks funky. every other LED is dead while the next one is lit, sound or no sound.
And speaking of phones - shouldn't the phones output be regulated by the monitor or master fader? It isn't. Only way is to lower the volume at the input fader.
I have switched around the ribbon cables and even tried another S4000 master channel but the same problem continues to raise its ugly head, which should mean the problem isn't in the S4000 strip itself, right?
Could it be the fader? I have lifted the panel and all solders look perfect.....but there could of course be a faulty cable leading to the 4-pin molex.
Any suggestions?
And speaking of phones - shouldn't the phones output be regulated by the monitor or master fader? It isn't. Only way is to lower the volume at the input fader.
I have switched around the ribbon cables and even tried another S4000 master channel but the same problem continues to raise its ugly head, which should mean the problem isn't in the S4000 strip itself, right?
Could it be the fader? I have lifted the panel and all solders look perfect.....but there could of course be a faulty cable leading to the 4-pin molex.
Any suggestions?