The state of the art of 3D printing is so advanced by now the equivalent of an electrically conducting coil with insulation could be formed by a special print head
The dimentional metrics Im getting from my 3D print Wizard tell me a mini tape wound printed core is very possible ,
So a traditional coil winder set up but with a print head exuding a conductive matrix into an insulating tube instead of copper /varnish,
The subject of sintering was mentioned lately , could silver be sintered down a microscopic hollow ptfe tube to form a conductive winding of extreme precision?
The dimentional metrics Im getting from my 3D print Wizard tell me a mini tape wound printed core is very possible ,
So a traditional coil winder set up but with a print head exuding a conductive matrix into an insulating tube instead of copper /varnish,
The subject of sintering was mentioned lately , could silver be sintered down a microscopic hollow ptfe tube to form a conductive winding of extreme precision?
