Racking an Amek BIG1 Channelstrip

[Paul Douwsma]

Hello all!

At this moment I'm trying to make an Amek BIG1 channelstrip operate at it's own.  Last week I spent trying to figure out de pinout of the edge connector of the card. I included the results in the attached file.

I'm dealing with the following questions;

• Am I correct on the 0V anaground on the  connector?
• Am I correct on the  5V ?
• Where does the digi GND go and does it have to be separate from the 0V anagnd?
• Where do I connect the sleeves of all jack connectors at the card?

If anyone could provide me with some pointers , hints or perhaps a schematic of the channel, it would be very much appreciated! I'll post my findings!

Regards form Holland, Paul

 

[sahib]

I can't release the schematics but the pin configuration is attached.

 

[Paul Douwsma]

I can release the schematics but the pin configuration is attached.

Great!  Thanks sahib! This will help me surely with my experiment!  I will keep you and other members posted! Thanks again!  Regards,  Paul