lanxe
Well-known member
i want to rack up a couple of preamps out of an old console that i have. i know that the power needs to be +-15vdc
so can i just use something like this in the rack case:
mouser part number 418-CFM1003S
http://www.mouser.com/index.cfm?han...uctid=408500&e_categoryid=103&e_pcodeid=04153
or do i need something else. i would like to stay away from wallwarts, but, if necessary i will.
another question...........
with this, or any psu, do i just run the two channel strips in parallel (knowing that the voltage will be the same across both channels in parallel)? this splits the current right? is that a problem? i am not exactly sure what current these are regulated for, or if that even matters.
thanks guys,
ryan
so can i just use something like this in the rack case:
mouser part number 418-CFM1003S
http://www.mouser.com/index.cfm?han...uctid=408500&e_categoryid=103&e_pcodeid=04153
or do i need something else. i would like to stay away from wallwarts, but, if necessary i will.
another question...........
with this, or any psu, do i just run the two channel strips in parallel (knowing that the voltage will be the same across both channels in parallel)? this splits the current right? is that a problem? i am not exactly sure what current these are regulated for, or if that even matters.
thanks guys,
ryan