deep_transmissions
Member
- Joined
- Jun 14, 2019
- Messages
- 6
I have a couple pultec clones in 500 series format and I want to swap out a handful of inductors and caps in the filter section. I was wondering if I could socket those holes in the PCB with a female socket and then start doing a solderless swap of caps and inductors until I get the EQ shelf and boosts right to my ears on some test recordings.
Has anyone done this?
Can you recommend sockets that will take some different width legs/wires from various components?
Will probably try some newer ones as well as some old russian PIOs and maybe some mustards.
Suggestions and guidance would be hugely appreciated, thank you!
Has anyone done this?
Can you recommend sockets that will take some different width legs/wires from various components?
Will probably try some newer ones as well as some old russian PIOs and maybe some mustards.
Suggestions and guidance would be hugely appreciated, thank you!