synthetic
Well-known member
I'm considering building a GSSL Mix Compressor with an analog summer built into it. The idea would be to have four stereo pairs (probably on a DB25 connector) mixed together using the summing amp from an SSL 4K, followed by the Gyraf GSSL Mix Comp.
Does anyone have the schematic for this circuit so I can see how involved a project it would be? I looked at the lo-res schematics of the 82E26 on Gyraf's site, but it's tough to read the values and for me to suss out exactly what's going on.
http://www.gyraf.dk/gy_pd/ssl/ssl_82e26.gif
I see pin 5 labeled "- mix buss", and theres a pin below that with no label. Is that "+ mix buss" or voltage? I assume that the output of T2 is the end of the mix amp and the beginning of the mix compressor?
Assuming that I would start from a GSSL board, some of the components of the mix amp may already be there. I was thinking about a small additional board to contain the mix amp.
That's enough questions for one post. Thanks for your help.
Does anyone have the schematic for this circuit so I can see how involved a project it would be? I looked at the lo-res schematics of the 82E26 on Gyraf's site, but it's tough to read the values and for me to suss out exactly what's going on.
http://www.gyraf.dk/gy_pd/ssl/ssl_82e26.gif
I see pin 5 labeled "- mix buss", and theres a pin below that with no label. Is that "+ mix buss" or voltage? I assume that the output of T2 is the end of the mix amp and the beginning of the mix compressor?
Assuming that I would start from a GSSL board, some of the components of the mix amp may already be there. I was thinking about a small additional board to contain the mix amp.
That's enough questions for one post. Thanks for your help.